If your battery is discharged or your battery becomes older and rather to hold the power in the battery then you have to use some technical process to start the car. The process of jumpstart near me is:
- You have to place the car in the proper position which must be nearer to each car by facing the car battery because some cars have the battery in the trunk and some may be contained between the engine and passenger compartment.
- You have to identify the positive and negative terminal of the battery because you have to connect the battery with the proper terminal to start.
- The positive terminal must be red and negative terminal must be black cable
- You must park with a certain distance between the car battery and you must turn off all radio and lights and other electrical components along with the engine.
- Make sure that the things in the car is disabled and park the car without touching each other if the car touches then it may cause dangerous to electrical between the cars
- You must make sure that you have enough safety precaution such as gloves and glasses
- You must check the battery that if any cracks or any damage in the battery and if it is damaged then avoid using it because it may cause any dangerous while the jumping process
- Remove the disabled automobile batteries and make the cable and terminals clean and you have to use the brush to remove the corrosion.
- You have to reconnect the battery to jump the car and remove any one of the positive post covers if it is needed.
- Now you’re going to use the jumper cable to connect with the battery where the jumper cable has both red and black cable and you must make sure that the red and black must not touch each other once the battery gets connected.
- While connecting the jumper cable then you have to connect red cable clamp with the positive post of the dead battery
- Connect another cable clamp with the negative post to the good battery.
- Connect black cable clamp with the negative post to the good battery
- Don’t connect the remaining clamp to the post of the dead battery. Instead, you have to connect the cable to the exposed metal piece.
- While connecting the final cable clamp make sure that all the batteries are connected in the perfect process.
- Try to start the good battery car and if it is start wait for 5 minutes
- After 5 minutes you have to start the dead battery car and try to start and if it does not start then wait for a few minutes and try again until it starts.
- Once the dead battery car starts then you have to remove the jumper cable in the reverse order of connection immediately from the exposed metal piece. Now the car gets started and enough to run.
